Section

Using Your Hemisphere Lantern

Removing and replacing the engine

To remove the engine, place the lamp on a surface and remove the upper housing to reveal the engine.

To install the engine simply place it in the housing base and replace the upper.

First time use

The first time you power up your Voltra lamp you will need to activate the engine by pressing and holding the power button for 5 seconds.

You will only need to do this once on your very first use.

Checking the battery level

The bottom of the engine will automatically illuminate battery level indicator lights.

Green lights indicate the battery level. A single amber light shows when the lamp has 5% or less battery remaining.

Changing the brightness levels

Tapping the power button once will switch the engine on at the highest brightness level.

Further taps on the power button will cycle through three levels of brightness until the lamp switches off.

Switching between light modes

While the engine is powered on press and hold the power button for 5 seconds to change the light mode.

Your lamp Voltra lamp has two modes, static and candle light.

Charging your lamp

Remove the engine from the lamp housing and place it on the charging pad.

Coloured lights on the charger will indicated charging status.

For sales enquiries or if you’d like to work with us, get in touch.

We use cookies to improve your experience on our website. By continuing to browse our site you accept our cookie policy.

Pre-loader