Using Totem or Stem Style Lights 

Drop element here!

First Time Use

The first time you power up your Voltra lamp you will need to activate the engine by pressing and holding the power button for 10 seconds.

You will only need to do this once on your very first use.

Removing and Replacing the Engine

To remove the engine, place the lamp on a flat surface and twist the housing clockwise whilst raising it off the engine.

Lower the housing and twist anti-clockwise to install the engine.

Checking the Battery Level

Turning the lamp over will illuminate the engine indicator lights.

Green lights indicate the battery level. A single amber light shows when the lamp has 5% or less battery remaining.

Changing the Brightness Levels

Tapping the power button once will switch the engine on at the highest brightness level.

Further taps on the power button will cycle through three levels of brightness until the lamp switches off.

Switching Between Light Modes

While the light is powered on press and hold the power button for 5 seconds to change the light mode.

Your lamp Voltra lamp has two modes, static and candle light.

Charging Your Lamp

Either place the assembled lamp or the individual engine on the charging pad.

Coloured lights on the charger will indicated charging status.

For sales enquiries or if you’d like to work with us, get in touch.

We use cookies to improve your experience on our website. By continuing to browse our site you accept our cookie policy.